Process steps:
1. Cleaning the ground or dewaxing
Place "careful slipping" or "construction in" signs, remove the effects of the work;
Remove adhesive fouling and pick up large pieces of debris.
Machine cleaning
If there is old wax on the ground, the wax will be prepared by 1:4 (waxed water: water) to be used as a solution.
To drag the solution wet to the working area, the area should not be greater than 100 square meters.
Wait for 10 minutes at the same time to keep the wetting state.
Wear the ground machine with black brushes evenly;
A water absorbent is used to remove the ground water from the ground.
In the corner and the wall, and other cleaning machine can not be used by hard brush manually removed.
Use clean water for two times, with clean towing and water press, covering all the ground where the wax is touched until the water does not foam.
Wait for the dry ground, before waxing.
Two, waxing
Make sure the ground is dry;
Use a clean mop (coated water heater) wax mop head material for synthetic fiber or blended suggestions;
Wax (generally use super light wax, anti-static floor anti-static floor wax), these generally do not need to wax polishing, there is shiny.
Of course, you should pay attention to: when you wax, you should choose a better day for the weather, because the air is a little dry, and the wax will dry a little faster.
Waxing as far as possible when using a direction of waxing, thus preventing wax surface fluctuation.
Wax is generally used in epoxy floor, PVC floor, paint the ground more.
According to the specific circumstances can be over two times second times when the wax should wait for 30~45 minutes, to ensure that the wax surface dry (due to site conditions, such as high temperature and high humidity may be harmful, 30~45 minutes after the hand touch surface wax if still feel sticky, please wait until sticky hands again second times waxing; if the second times waxing process, feel a strong sense of the mop drag, wax surface caused by dry, please wait after dry, so when a wax wax) in the selection of customers in the purchase of the washing machine has the function of the machine on it.
Solid wax, the wax needs to be polished, and the more lustrous.
The solid wax is generally used in the cement ground, the terrazzo ground, the marble ground and so on, because these surfaces have strong water absorption and rough surface. The use of solid wax can cover the rough surface, the wax surface than the wax wax surface wear resistance.
Wax method: clean the ground as the first half, and then apply the solid wax evenly to the ground. The high speed polishing machine is then used for high speed polishing of the wax surface. Attention to the polishing time limit: generally in the good wax for 2 hours -5 hours between polishing effect will be better.
So when using solid wax to wax, it is best to use the machine with high speed when choosing the machine, and it can be washed and polished. Sometimes it has to do with the choice of wax. The specific conditions need to be consulted with the floor wax distributors on the specific use of wax.